S550 Metric to Standard Brake Line Adapter

S550 Metric to Standard Brake Line AdapterThe Brake Line Adapter will allow the common 3 8 24 Inverted Flare 3 16" Brake Line to match up to the M10x1. 5 Bubble Flare Brake Line on the S550 Rear Differential Assembly! It is difficult to find the correct adapter to go from standard brake line sizing to metric brake line sizing, especially on modded and upgraded parts for classic vehicles. This 3 16" hard brake line has a 3 8 24 Inverted Flare fitting on one end, and an M10x1. 5 Bubble Flare

Tighten the two nuts to your desired location to ensure proper parking brake engagement

The bar ends and mount brackets are powder coated in Satin Black for a long-lasting

right and left hand rod ends and jam nuts

With lots of aftermarket fuel pumps and carburetor fuel inlet lines available

then this Kit will allow you to finish the brake line from there to the brake lines attached to the S550 rear calipers

Please do your own research to determine if you can use this toggle switch to override the operation of your electric fan(s)

I will update once I have photos of the kit installed on the '67-'70 Mustang

Simply unbolt the upper control arm

or black hardware for the powder coated Trim

make sure your cart has a quantity of 2 of this item before you check out

so the suspension can work more precisely

The video for the install is for the 1964-1968 Mustang