6" OD X 4" Long

6" OD X 4" LongStandard aluminum intake tubing. 6061T6 alloy . 125 wall thickness. Cuts easily with a hack saw. About 1 to 1 1 4 inches on each end goes inside an intake hose (minimum 1 inch). Mill finish (as it arrives at our location from the mill after traveling on a truck and being handled several times) may have minor defects and small scratches, but no dents or major defects. Made in USA.

63" ID (5-ply) and 3

This reducing hump hose connects 6" OD and 5" OD intake tubes

Spring-loaded T-bolt clamps assure a firm hold

Special 7 inch length can be used on most LS1 engines

This reducing 68-degree intake elbow can be used any place where you are connecting a 7" OD tube and a 6" OD tube

8" long version

This reducing insert adapts a 2-1/2" ID intake hose to a 2" OD tube

This charge air cooler hose with rings and is ideal for aftercooler systems

This 90 degree silicone elbow is 1-1/4" ID

This 45 degree silicone elbow is 4" ID

Recommended clamps are CT350 on the small end and CT400 on the big end

This reducing 90-degree intake elbow can be used where you are connecting a 3" OD tube and a 2-1/2" OD tube